Imágenes de página
PDF
ePub

In the early days of experiments the loss was so great as to be commercially prohibitive. With the perfected modern dynamo the loss is not greater than fifteen per cent; but even this, it will be noted, makes electricity a relatively expensive power as compared with steam,except, indeed, where some natural power, like the Falls of Niagara, can be utilized to drive the armature.

A MYSTERIOUS MECHANISM

The efficiency of the modern dynamo is due largely to the fact that when the poles of the magnet are made to face each other, the lines of magnetic force passing between these poles are concentrated into a narrow compass. With the ordinary bar magnet, as everyone is aware, these lines of force circle out in every direction from the poles in an almost infinite number of loops, all converging at the poles, and becoming relatively separated at the equator in a manner which may be graphically illustrated by the lines of longitude drawn on an ordinary globe.

It is obvious that with a magnet of such construction only a small proportion of the lines of magnetic force could be utilized in generating electricity. But, as already mentioned, when the magnet is so curved that its poles face each other, the lines of force, instead of widely diverging, pass from pole to pole almost in a direct stream. The strength of this magnetic stream may be increased almost indefinitely by winding the iron core of the magnet with the coil of wire through which the electric current is passed, thus constituting the electro

[graphic][subsumed][subsumed][subsumed][merged small]

Fig. 1. A small example of the original commercial form of the drum armature machine, patented in 1873 by Dr. Werner Siemens and F. Von Hefner Alteneck. The armature is a development of the Siemens shuttle form of 1856, and gives a nearly continuous current. Fig. 2.-An early experimental dynamo. Fig. 3. Ferranti's original dynamo, patented in 1882-1883. The field magnets are stationary and consist of two sets of electro-magnets each with 16 projecting pull pieces, between which the armature revolves. Fig. 4.-The gigantic rotary converters of the Manhattan Elevated Railway.

magnet which has replaced the old permanent magnet in all modern commercial dynamos.

An electromagnet may be sufficiently powerful to lift tons of iron. The force it exerts, therefore, is very tangible in its results. Yet it seems mysterious, because so many substances are unaffected by it. You may place your head, for example, between the poles of the most powerful magnet without experiencing any sensation or being in any obvious way affected. You may wave your hand across the lines of force as freely as you may wave it anywhere else in space. Apparently nothing is there. But were you to attempt to pass a dumb-bell or a bar of iron across the same space, the unseen magnetic force would wrench it from your grasp with a power so irresistible as to be awe-inspiring.

Similarly, the armature, when its coils of wire are adjusted between the poles of the magnet, is held in a viselike grip by the invisible but potent lines of magnetic force which tend to make it revolve. It requires a tremendous expenditure of energy-supplied by the steam-engine or by water power-to enable the coiled wires of the generating armature to stem the current of magnetic force, which is virtually what is done when the armature revolves in such a way as to produce electrical energy. Part of the mechanical energy thus expended is transformed into heat and dissipated into space; but the main portion is carried off, as we have seen, through the coiled wires of the armature in the form of what we term the current of electricity, to be re-transformed in due course into the mechanical energy that moves the

car.

It appears, then, that the phenomena of the electric dynamo depend upon the curious relations that exist between magnetism and electricity. Granted the essential facts of magneto-electric induction, all the phenomena of the dynamo are explicable. But how explain these facts themselves? Why is an electric current generated in a coil of wire moving in a magnetic field? And why is a wire carrying a current of electricity, when placed across a magnetic field, impelled to move at right angles to the lines of magnetic force? No thoughtful person can consider the subject without asking these questions. But as yet no definitive answer is forthcoming. Some suggestive half-explanations, based on an assumed condition of torsion or strain in the ether, have been attempted, but they can hardly be called more than scientific guesses.

Meanwhile, it may be understood that the mutual relations of the magnetic and electrical forces just referred to are not at all dependent upon the manner in which the electric current is generated. The magnetoelectric motor may be operated as well with a chemical battery as with such a mechanical generating dynamo as has just been described. The storage-batteries which have been employed in some street railways and those which propel the electric cabs about our city streets furnish cases in point. The only reason these are not more generally employed is that the storage battery has not yet been perfected so that it can produce a large supply of electricity in proportion to its weight, and produce it economically.

« AnteriorContinuar »